Easy Steps on How to Adjust Front Derailleur

Easy Steps on How to Adjust Front Derailleur

How To Adjust Front Derailleur – There are easy steps you can do when it comes to how to adjust front derailleur of your bicycle. To start adjusting, you will first need to have a hex wrench, screwdriver, and a coin. By the way, to traverse through hard terrains, you might want to consider buying the best socks for sweaty feet. Now, let us head to the tutorial.

Adjusting the height

Start the steps by shifting the derailleur to the direction where the middle front part of the chainring is located- make sure that there is a gap which is measured at one to two millimeters around the chainring at the outside and front with the lower part of the cage plate which is located at the lower edge. Use the coin to figure out whether the gap is adequate or not. By the way, the tension of the inner wire can be loosened and you need to shift to the lowest part of the chainring- you can do this when you wish to increase or decrease the height of the derailleur.

Adjusting the rotational angle

Paralleling the chain of your bike to the front side of the derailleur cage must be done. Otherwise, the shift may not be satisfying when you try to! Well, you need to move the chain to the direction where the outside part of the rear sprocket as well as the chainring is located. Make sure the chain is now in line with the outer cage of the derailleur when seen from above.

Setting the limit screws

The next part on how to adjust front derailleur is to set the limit of the screws that are available in your bike. The step should be easy as most bikes have L and H markings with the first letter indicating its feature to stop any movement to the direction where the inner chainring is located, while the last one is for the outer part.

Indexing adjustment

To adjust the indexing, the first thing you can do is to move the chain to the inner part of the sprocket located at the rear and the middle front chainring. Make sure the gap between that  inner cage plate as well as the chain is as tiny as possible and is measured without rubbing. If the gap is too large, reduce it by increasing the tension of the inner part of the wire by rotating the adjustment system of the barrel away from the housing. Oh, by the way, decreasing the tension of the inner part of the wire can be done by rotating that barrel adjuster into the housing is also important when you wish to reduce any rubbing between the chain and the inner part of cage plate that your bike has. Those are the ways to do in order to set your derailleur. These steps are important to make your bicycle as smooth as possible when you are riding it. We hope you find the ways on how to adjust front derailleur useful! 

ajusting front derailleur for easy use